Vision inspection selection

When to buy a vision camera or a complete inspection station

List what the current line already does. If it presents the part consistently and can act on a pass/fail signal, an inspection module may be enough. If feeding, positioning or reject handling also needs design, compare complete stations.

Draw the boundary of the work

Define who supplies the holder, lighting, trigger, camera, controller and reject mechanism. For an existing line, name who owns the PLC interface and accepts the inspection result. Small gaps in these responsibilities can determine the scope of the quote.

Separate the measurement method from the station scope

A 2D or 3D sensor can be integrated into a complete station. The measurement choice follows the acceptance rule. The station scope follows the mechanical and controls work still required. Describe these as separate decisions when asking for comparable quotes.

Include reject handling in the acceptance test

Test with known-good and known-bad parts at the required speed. Watch what happens after a reject signal: does the downstream device remove the right part, confirm removal and record the event? For sorting equipment, include feed interruptions and recovery in the test.

Ask for a quote that names the exclusions

Use one brief across suppliers. Ask for equipment, fixtures, software, commissioning and support as separate lines. Specify which samples, line conditions and acceptance criteria each quote assumes. Have the supplier confirm any installation and local support commitments.

Compare the options for your part

Request an application review →See an example review

Leave a message

We use your details to respond. We’ll ask before sharing your project with prospective suppliers.